Related Manuals for Projecta IS2000
Summary of Contents for Projecta IS2000
- Page 1 INTELLI-START 12/24V LITHIUM JUMP STARTER and Portable Power Bank P/No. IS2000 Intelli-start.com...
-
Page 2: Important Safety Information
IMPORTANT SAFETY INFORMATION Please read this manual thoroughly before use and store in a safe place for future reference. WARNINGS • This unit has been designed for vehicles with 12V DC and 24V DC electrical systems only. • This appliance contains batteries that are non-replaceable – during charging, the battery must be placed in a well-ventilated area (for chargers for batteries that release gases into the atmosphere during normal charging). -
Page 3: Important Charging Information
2000 battery cycles. JUMP STARTING PERFORMANCE • This IS2000 is suitable for starting most 12V DC vehicles up to 8.0 litre petrol and 6.0 litre diesel as well as 24V DC 7.0 litre diesel vehicles. •... - Page 4 The IS2000 allows charging of phones, tablets, and other small portable devices. 5V DC USB CHARGING • The IS2000 can be charged via a vehicle’s USB output or supplied 12/24V DC socket. PREMIUM SPARK FREE CLAMPS • Ensures safe jump starting.
-
Page 5: Over Temperature Protection
Before the IS2000 jump starter activates the jump start function, it will sound an alarm if the vehicle battery is higher than 30V DC. In addition, the IS2000 will deactivate the jump start function and sound an alarm if the vehicle battery is higher than 14.6V DC on 12V DC vehicle or 30V DC on 24V DC vehicle during jump start. -
Page 6: Product Overview
IS2000 jump starter battery status. Message overview Icon. IS2000 jump starter suggested action. The LCD display shows the IS2000 jump starters status and supports its operation. In addition to the primary function the LCD display shows the following icons: • USB icon (ON/OFF) •... -
Page 7: Jump Starting
Turn the vehicle’s ignition to ON and start the vehicle. After the engine has started, leave the clamps connected for a minimum of 40 seconds to allow the IS2000 RRT to charge the unit. Once the IS2000 is fully charged, the RRT will shut off to avoid overcharging. -
Page 8: Override Mode
Note: • If the IS2000 flood light is in operation, the “LIGHT ON” icon will appear on the display or the lamp icon in the upper left corner will light up. • Flood light will turn off if the internal battery has low charge or after 4 hours if... -
Page 9: Usb Output
24 hours. The typical charging time is 4 hours if the battery is at 50% state of charge. Note: It is recommended to fully charge the IS2000 before the first use, as the IS2000 is shipped only partially charged. - Page 10 TIMEOUT” screen if the charging cycle cannot be completed in 24 hours. Short circuit The IS2000 detected the clamps are short- circuited. The IS2000 will not jump start until the short circuit is resolved. Please disconnect the clamps and check the vehicle electrical system. Overload...
-
Page 11: Frequently Asked Questions
TIP Turn on the flood lights to warm up the jump starter at the expense of battery charge. Why didn’t my IS2000 start my vehicle? There could be a number of reasons why the IS2000 did not start your vehicle. Check the following: •... -
Page 12: Warranty Statement
Phone: (03) 9730 6000 Fax: (03) 9730 6050 National Toll Free: 1800 113 443 NEW ZEALAND OFFICE Griffiths Equipment Ltd. 19 Bell Avenue, Mount Wellington, Auckland 1060, New Zealand Phone: (09) 525 4575 Fax: (09) 579 1192 IS2000 Intelli-start.com Issue 2 05.11.2022...
Need help?
Do you have a question about the IS2000 and is the answer not in the manual?
Questions and answers