Error And Alarm Messages - Projecta IS1400 Manual

UNDERSTANDING YOUR JUMP STARTER

ERROR AND ALARM MESSAGES

Error type Error detail
Low battery The internal battery voltage of the IS1400 is
too low for a jump start. Please charge the
IS1400 immediately.
Reverse The clamps are reverse connected to the
polarity
vehicle battery. The clamps should be
disconnected and reconnect with the
correct polarity.
Overvoltage The vehicle battery voltage is too high for a
12V DC vehicle. Please disconnect the clamp
and ask a qualified mechanic to check the
vehicle's alternator.
Jump starter The IS1400 will display the "CHARGER
timeout
TIMEOUT" screen if the charging cycle cannot
be completed in 24 hours.
Short circuit The IS1400 detected the clamps are short-
circuited. The IS1400 will not jump start until the
short circuit is resolved. Please disconnect the
clamps and check the vehicle electrical system.
Overload The IS1400 detected excess current (more than
the contactor and internal battery can handle)
occurred. Jump starting will be disabled. Please
disconnect the clamps and check the vehicle
electrical system.
Failure
The IS1400 detected a malfunction of internal
contactors or abnormal internal battery
voltage.
Low
The operating temperature is too low for the
temperature IS1400 to perform its required functions.
High The operating temperature is too high for the
temperature IS1400 to perform its required functions.
Surge The jump starter has detected surge protection
protection
system has failed. User is advised to contact
failure customer service.
10
Error display