Important Safety Information - Projecta INTELLI-START PJ-IS2000-2 Owner's Manual

IMPORTANT SAFETY INFORMATION

Please read this manual thoroughly before use and store in a safe place for future reference.
WARNINGS
• This unit has been designed for vehicles with 12V DC and 24V DC electrical systems only.
• Risk of explosive gas. Working in the vicinity of car batteries can be dangerous. Batteries
release explosive gases during normal operation, charging and jump starting. Before
using this jump starter, read and follow the instructions carefully. Follow all manufacturer's
instructions and warnings of the vehicle's battery and other equipment being used.
• Jump start 12V DC or 24V DC lead acid and LiFePO4 batteries. Do not use to jump start
dry cell batteries commonly found in household appliances. These batteries may burst and
cause serious injury and/or property damage.
• Do not smoke, use matches, use a cigarette lighter, or allow a spark or flame near the
battery.
• Do not allow metal to come in contact with the battery posts. It may spark or short-circuit
the battery and cause an explosion/fire.
• Remove rings, bracelets, necklaces, and watches when working at the vehicle and / or
jump starting a vehicle.
• The jump starter contains a sealed non-spillable Lithium Iron Phosphate battery (LiFePO
This must be disposed of properly.
• Ensure correct polarity when connecting to vehicle.
• The jump starter is not designed to be left outside for extended periods of time or
submerged in water.
• Do not store the jump starter in temperatures above 113°F (45°C) or below 14°F (-10°C) as
this can affect the health of the internal battery.
• Always wear eye protection when operating the jump starter.
• Although the jump starter has been designed to protect the battery, do not drop the jump
starter or attempt to pierce it in anyway. This can result in an explosion and or fire.
• If the jump starter is physically damaged in any way, it should not be used.
• Not intended for people (including children) with reduced physical or mental capability.
• Do not try and charge the unit via its own USB output as this will damage the jump starter
and the USB output.
• Using any USB cable other than what is supplied may reduce the charging performance of
the jump starter.
• Do not allow positive/red and negative/black clamp touching each other when in override
mode and 12V mode.
• When in manual override, pay careful attention not to reverse-connect clamp or short-
circuit.
• Do not charge jump starter from laptop/computer USB ports.
• Make sure to have strong clamp connection to starting battery to maximize jump starting
current.
2
).
4