Important Safety Information - Projecta JS900 Manual

IMPORTANT SAFETY INFORMATION

Please read this manual thoroughly before use and store in a safe place for
future reference.
WARNINGS
• This jump starter has been designed for 12V vehicles only.
• Risk of explosive gas. Working in the vicinity of car batteries can be dangerous.
Batteries release explosive gases during normal operation, charging and while jump
starting a battery. Before using this jump starter, read and follow the instructions
carefully. Follow all manufacturer's instructions and warnings of the vehicle's battery
and other equipment being used.
• Jump start 12V DC automotive lead acid batteries only. Do not use to jump start dry
cell batteries commonly found in household appliances. These batteries may burst
and cause injury and/or property damage.
• Do not smoke, use matches, use a cigarette lighter, or allow a spark or flame near
the battery.
• Do not allow metal to come in contact with the battery posts. It may spark or
short-circuit the battery and cause an explosion/fire.
• Remove rings, bracelets, necklaces, and watches when working at the vehicle and/or
jump starting a vehicle.
• The jump starter contains a sealed non-spillable Lithium Iron Phosphate battery
(LiFePO ). This must be disposed of properly.
4
• Ensure correct polarity when connecting clamps to vehicle.
• The jump starter is not designed to be left outside for extended periods of time or
submerged in water.
• Do not store the jump starter in temperatures above 45˚C or below -10˚C, as this can
affect the health of the battery.
• Always wear eye protection when operating the jump starter.
• Although the jump starter has been designed to protect the battery, do not drop the
jump starter or attempt to pierce it in anyway. This can result in an explosion
and/or fire.
• If the jump starter is physically damaged in any way, it should not be used.
• Not intended for people (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction – children being supervised not to play with the appliance
– only to be used with the power supply unit provided and it must only be supplied
at SELV (safety extra low voltage, less than 60V DC).
• Do not attempt to charge via the USB output as this will damage the jump starter
and the USB output.
• Do not allow the positive (red) clamp and the negative (black) clamp to touch each
other during jump starting.
2