Related Manuals for Projecta JS900
Summary of Contents for Projecta JS900
- Page 1 LITHIUM 12V EMERGENCY JUMP STARTER and Portable Power Bank P/No. JS900, JS1200 www.projecta.com.au...
-
Page 2: Important Safety Information
IMPORTANT SAFETY INFORMATION Please read this manual thoroughly before use and store in a safe place for future reference. WARNINGS • This jump starter has been designed for 12V vehicles only. • Risk of explosive gas. Working in the vicinity of car batteries can be dangerous. Batteries release explosive gases during normal operation, charging and while jump starting a battery. -
Page 3: Important Charging Information
• The JS900 is suitable for starting most 12V petrol vehicles up to 6.0 litres. • A fully charged JS900 can do up to 9 starts (with a flat vehicle battery). JS1200 • The JS1200 is suitable for starting most 12V petrol vehicles up to 7.0 litres and diesel vehicles up to 4.5 litres. -
Page 4: Usb Charging
Electronic Fuel Injection (EFI) and computer management systems. TOTAL SAFEGUARD PROTECTION • The JS900 and JS1200 jump starter offers total safeguard protection including additional protections like Battery & Switch Short Circuit Protection, Over Current Protection, Over Cranking Protection, Low Voltage Indication. -
Page 5: Specifications
SPECIFICATIONS P/No. JS900 JS1200 Battery Battery Capacity 1.6Ah at 12.8V 3.0Ah at 12.8V 6,400mAh at 3.2V 12,000mAh at 3.2V 20.48Wh 38.4Wh Battery Chemistry Lithium Iron Phosphate (LiFePO Lithium Iron Phosphate (LiFePO Peak Amps 900A 1200A Clamp Power 240A 400A Voltage... -
Page 6: Product Overview
PRODUCT OVERVIEW Premium Spark Durable Padded Free Clamps Carry Case Jump starter with Bridging Battery Status Clamp Charging Port Strap 2.1A USB Indicator Connection LED Accessory Port Battery Clamps Connection Port On/Off Jump Start LED Flood Override Light Button Flood Light ISEUSB 12V 2.1A Micro USB On/Off... -
Page 7: Jump Starting
JUMP STARTER INSTRUCTIONS Notes: • Instructions for negatively earthed vehicles only. (Most vehicles after 1970 are negatively earthed). • Before jump starting a vehicle, it is recommended to ensure the jump starter is fully charged. JUMP STARTING Step Instruction Display The jump starter should be charged for around 8 hours prior to first use and as soon as possible after each use. -
Page 8: Battery Status Indicator
UNDERSTANDING YOUR JUMP STARTER CLAMP CONNECTION LED Jump start Status Jump starter clamps connected to vehicle and ready to jump start Green solid Jump starting for more than 5 seconds Yellow flash twice, pause & repeat Battery or jump starter switch, over-temperature Red / Green alternate flashing Battery charging temperatures >45°C or <0°C Red / Green alternate flashing &... - Page 9 See battery status indicator table on page 8. When the jump starter is fully charged, after 4 hours for the JS900 and 8 hours for the JS1200. Simply disconnect the leads and put the jump starter away.
-
Page 10: Flood Light
FLOOD LIGHT Step Detail Display Press the light button and the light will turn on. Press the light button again to turn the light off when you are finished. Note: If the jump starter is off and the light button is pressed, the button will need to be pressed for at least half a second before the light will turn on. -
Page 11: Frequently Asked Questions
4. Ensure the vehicle being jump started is in the specified vehicle engine size of the jump starter. For JS900 up to most 6.0 litre petrol vehicles and for JS1200 up to most 7.0 litre petrol vehicles and 4.5 litre diesel vehicles. -
Page 12: Warranty Statement
Phone: (03) 9730 6000 Fax: (03) 9730 6050 National Toll Free: 1800 113 443 NEW ZEALAND OFFICE Brown & Watson International NZ Ltd. 19 Bell Avenue, Mount Wellington, Auckland 1060, New Zealand Phone: (09) 525 4575 IS578 www.projecta.com.au Issue 2 16.05.23...
Need help?
Do you have a question about the JS900 and is the answer not in the manual?
Questions and answers