Usb Output - Projecta IS1400 Manual

USB OUTPUT

The USB output allows the user to charge external compatible devices.
Step Detail
1 If the IS1400 is not in jump starting operation, and the user connects an external
device to charge the following screen will be displayed.
Note: The USB output will be automatically disabled in the following conditions:
• IS1400 is turned off
• Once USB device is fully charged
• Exit mode
• Jump start mode
• Error mode
• Rapid Recharge (RRT) mode
• Low battery condition
• Battery temperature below -20°C or above 60°C, or ambient temperate above 45°C
CHARGING
Step Detail
1 Plug a USB-C cable into the USB-C port on the IS1400 to begin
charging the jump starter.
**Using a non-supplied charger and USB cable may extend
charge time.**
2 The battery charging screen will be shown when the USB-C cable is
plugged into the USB-C socket of the IS1400.
3 When the IS1400 is fully charged, it will display "CHARGING
COMPLETE".
4 The IS1400 will display the "CHARGER TIMEOUT" screen if the
charging cycle cannot be completed in 24 hours. The typical charging
time is 3 hours if the battery is at 50% state of charge.
Note: It is recommended to charge the IS1400 before the first use, as the IS1400 is shipped only partially charged.
Display
Display
9