Table of Contents
Advertisement
IMPORTANT SAFETY INFORMATION
Please read this manual thoroughly before use and store in a safe place for future reference.
WARNINGS
Do not jumpstart 24V batteries. This unit is designed for 12V vehicles only and will not
•
operate when used on 24V vehicles.
•
Risk of explosive gas. Working in the vicinity of car batteries can be dangerous.
Batteries release explosive gases during normal operation, charging and while jumpstarting
a battery. Before using this jumpstarter, read and follow the instructions carefully.
Follow all manufacturer's instructions and warnings of the vehicle's battery and other
equipment being used.
•
Jumpstart lead acid batteries only. Do not use to jumpstart dry cell batteries commonly
found in household appliances. These batteries may burst and cause injury and/or
property damage.
•
Do not smoke, use matches, use a cigarette lighter, or allow a spark or flame near the battery.
•
Do not allow metal to come in contact with the battery posts. It may spark or short-circuit the
battery and cause an explosion.
•
Remove rings, bracelets, necklaces and watches when working with a lead acid battery.
•
The Jumpstarter contains a sealed non-spillable Lithium Iron Phosphate battery. It must be
disposed of properly.
•
Ensure correct polarity when connecting to vehicle.
•
Do not submerge jumpstarter in water, keep out of the rain.
•
IS1500 is not rain proof and is not designed to be left outside of extended periods of time or
submerged in water.
•
Do not store the jumpstarter in temperatures above 45
health of the battery.
IMPORTANT CHARGING INFORMATION
•
Charge the IS1500 jumpstarter prior to use, this may take up to 24 hours.
•
Recharge the jumpstarter after every use and follow charging instructions.
•
When the jumpstarter is not in use ensure it is always on charge.
•
Do not allow the jumpstarter to become very flat. If the 'Low' BATTERY STATUS
LED is illuminated on the front of the unit, ensure the jumpstarter is charged
immediately.
FEATURES
RAPID RECHARGE TECHNOLOGY (RRT)
The Lithium Iron Phosphate (LiFePO
vehicles alternator. Leaving the clamps connected to the vehicle battery for 40 seconds will
recharge the jumpstarter to 100%* of the original charge status. Once the jumpstarter is fully
charged the RRT will shut off avoiding overcharging.
2
C or below -10
0
) battery is able to rapidly recover charge from the
4
C as this can affect the
0
Hide quick links:
Advertisement
Table of Contents
