Page 1
INTELLI-START 12V LITHIUM JUMP STARTER and Portable Power Bank Pour le manuel en français, visitez PROJECTA.US ou appelez le 1-888-489-9820. Para obtener el manual en español, visite PROJECTA.US o llame al 1-888-489-9820. WARNING: Cancer and Reproductive Harm. ADVERTISSEMENT: Cancer et problèmes e reproduction.
IMPORTANT SAFETY INFORMATION Please read this manual thoroughly before use and store in a safe place for future reference. WARNINGS • This unit has been designed for vehicles with 12V DC electrical systems only. • Risk of explosive gas. Working in the vicinity of car batteries can be dangerous. Batteries release explosive gases during normal operation, charging and jump starting.
• This PJ-IS1400-2 is suitable for starting vehicles with up to 10 cylinder gas and 5L diesel vehicles. • With 40 seconds of rapid recharge after each jumpstart, the PJ-IS1400-2 will not need to be recharged during the working day.
Page 4
• The PJ-IS1400-2 allows charging of phones, tablets, and other small portable devices. 5V DC USB CHARGING • The PJ-IS1400-2 can be charged via a vehicle’s USB output or supplied 12-24V DC socket. PREMIUM SPARK FREE CLAMPS • Ensures safe jump starting.
UNDER AND OVER-VOLTAGE PROTECTION • The PJ-IS1400-2 jump starter will deactivate and sound an alarm if connected to a vehicle battery which is higher than 14.6V DC, or if the internal battery is discharged to a level whereby the battery might be damaged.
PJ-IS1400-2 jump starter battery status. Message Overview Icon. PJ-IS1400-2 jump starter suggested action. The LCD display shows the PJ-IS1400-2 jump starters status and supports its operation. In addition to the primary function the LCD display shows the following icons: • USB icon (ON/OFF) •...
After the engine has started, leave the clamps connected for a minimum of 40 seconds to allow the PJ-IS1400-2 RRT to charge the unit. NOTE The PJ-IS1400-2 will not switch OFF as long the clamps are connected to the vehicle battery. RRT (Rapid Recharge Technology) may take more than 40 seconds depending how depleted the jump starter battery is.
Press button Note: • If the PJ-IS1400-2 flood light is in operation, the “LIGHT ON” icon will appear on the display • Flood light will turn off if the internal battery has low charge or after 4 hours if user...
24 hours. The typical charging time is 3 hours if the battery is at 50% state of charge. Note: It is recommended to charge the PJ-IS1400-2 before the first use, as the PJ-IS1400-2 is shipped only partially charged.
Page 10
TIMEOUT” screen if the charging cycle cannot be completed in 24 hours. Short circuit The PJ-IS1400-2 detected the clamps are short- circuited. The PJ-IS1400-2 will not jump start until the short circuit is resolved. Please disconnect the clamps and check the vehicle electrical system. Overload...
TIP Turn on the flood lights to warm up the jump starter at the expense of battery charge. Why didn’t my PJ-IS1400-2 start my vehicle? There could be a number of reasons why the PJ-IS1400-2 did not start your vehicle. Check the following: •...
Need help?
Do you have a question about the PJ-IS1400-2 and is the answer not in the manual?
Questions and answers