Laguna Tools SmartShop Maker Owner's Manual page 64

Error Code
P address must be integer
Dot angle and axis command
conflict
Inc. axis command and abs.
axis command conflict
Arc center vector and radius
conflict
Metric/Inch cmd. not available
under quiet mode
Corner round and chamfer
cmd. conflict
Invalid G Code
No main program assignment
Threading block feedrate
exceed
Tapping block feedrate
exceed
Overcut by tool radius too big
Exact stop wait timeout
64
SmartShop|Maker Owner's Manual
Potential Issue(s)
Programming error
Programming error
Programming error
Programming error
Programming error
Program error
Program error
The program is not loaded.
Program error
Program error
Tool compensation causes overcut
Servo vibration
Resolution(s)
Change P address into an
integer.
Check the machining program.
Decide to use incremental or
absolute command and enter
the correct command.
Check the machining program.
Please check the machining
program.
Do not let chamfer command
and fillet command exist in the
same line.
Enter the valid G-Code.
Specify the main program.
Decrease the cutting speed of
threading.
Decrease the cutting speed of
tapping.
Check the machining program to
decide whether this part of the
machining cancels radius
compensation.
1. Servo tuning.
2. Change parameters.