Laguna Tools SmartShop Maker Owner's Manual page 40

2. Check the dust extraction for blockages as large pieces could cause blockages.
3. Verify the electrical connectors are fitted tightly and correctly.
8.6 Common Error Codes
Error Code
EMERGENCY STOP ALARM
Low Air
No Tool
Over Travel
Spindle 1 brusher rise is not
in place alarm
Syntax Error
X, Y, or Z not yet back home
40
SmartShop|Maker Owner's Manual
Potential Issue(s)
The Emergency Stop button has
been pressed and not reset.
Air pressure is below the threshold
(recommended at 67 bar)
There tool loaded in the spindle.
The spindle has moved beyond the
parameters of the project program.
1. The airlines are swapped.
2. The dust head sensor is out of
place.
The dust head is down.
Programming error.
The machine is not homed.
Resolution(s)
Release the Emergency Stop
button by turning it clockwise.
1. Verify the air turned on.
2. Verify all air lines are
securely connected.
Load a tool in the spindle.
1. Verify the machine is
homed.
2. Verify the proper program
has been selected.
1. Verify the airline
connections.
2. Properly reposition the dust
head sensor.
3. Raise the dust head.
Check program syntax
according to symbol appears on
the screen.
Home the machine.