Laguna Tools SmartShop Maker Owner's Manual page 61

Error Code
Radius compensation cancel
at arc
Radius compensation startup
at arc
Wrong direct draw command
usage
Zero movement at corner in
direct draw
Invalid angle amount, A, in
direct draw
Dot chamfer amount bigger
than displacement
Block end point exceed
software limit
SmartShop|Maker Owner's Manual
Potential Issue(s)
Programming error
Programming error
Programming error
Programming error
Programming error
Programming error
Program error
Resolution(s)
Please check the machining
program.
Please check the machining
program.
Check machining program to
confirm that whether before and
after single block is suitable for
specifications.
1. Check machining program
to confirm whether inserted
value of rounding or
chamfer is suitable for
specifications.
2. Check to confirm whether
working plane and round
plane are the same.
Check machining program to
confirm that whether angle
amount A is suitable
specifications.
1. Check machining program
to confirm whether inserted
value of rounding or
chamfer is suitable for
specifications.
2. Check to confirm whether
working plane and round
plane are the same.
Check the machining program
and correct coordinate position.
61