Laguna Tools SmartShop Maker Owner's Manual page 63

Error Code
Repeat count, L, should be
integer
Incompatible data type
Tool length number, H, over
range
G10 table index, P, over
range
Tool radius number, D, over
range
Tool nose number over range
Subprogram call sequence
num., H, must integer
M99 return sequence
number, P, must integer
Workpiece number over
range
Dwell skip source, Q, must be
integer
Dwell skip source Q, over
range
SmartShop|Maker Owner's Manual
Potential Issue(s)
Programming error
Machining program is not
compatible with the Syntec
controller
Programming error
Program error
Program error
Program error
Program error
Program error
Program error
Program error
Program error
Resolution(s)
Please check the program and
use the repetitive times L in
integer.
Verify the date format is suitable
for controller.
Verify the tool length number, H,
is in the range of tool number.
Use reasonable value P in G01
table index.
Verify the tool radius number D
is in range of the tool number.
Verify the tool radius number D
is in the range of tool number.
Change the number H of
subprogram into an integer.
Change the return sequence
number P of M99 into an
integer.
Verify the number of work
pieces in the allowed range of
the controller.
Change the dwell skip source Q
into an integer.
Verify the dwell skip source Q in
the allowed range.
63