Laguna Tools SmartShop Maker Owner's Manual page 55

Error Code
Not set home position.
Absolute coder will not work
Absolute position battery
failure.
Can't leave home dog
Second Positive software limit
exceed
Second Negative software
limit exceed
Inhibit cycle start in moving
EOF in comment
No end of string character
Illegal variable
Expression too complex
SmartShop|Maker Owner's Manual
Potential Issue(s)
Do not use C25~to set the home of
the machine.
The battery of absolute encoder
has no power.
HomeDog is damaged
The motion of machine table
exceeds setting value.
The motion of machine table
exceeds setting value.
Manual command (JOG, INJOG,
and MPGJOG) cannot be sent
successfully.
Programming error
Programming error
Change error variable
Programming error
Resolution(s)
Absolute encoder to search
home.
Change the battery.
Use the electrical multimeter to
check whether the sensor of
HomeDog is damaged or wiring
connection is missing.
Remove alarm. Move axis in
negative direction out of stroke
protection software.
Remove alarm. Move axis in
positive direction out of stroke
protection software.
Remove alarm. Wait until
machine stops, then start
machining.
Using symbol "(*" before
command and symbol "*)" after
command
Check PRINT command of
program.
Check program variable and
confirm whether system uses
that variable.
Check whether logic is clear and
connect.
55