Laguna Tools SmartShop Maker Owner's Manual page 42

Error Code
Parameter storage access
failure, system halt
Machining data loss, re-
calibrate machining
I/O transmission error
Permanent storage data CRC
check failure, re-calibrate
before machining
Low memory, memory space
is less than 1M
42
SmartShop|Maker Owner's Manual
Potential Issue(s)
The second CF card error.
1. Shut down controller or power
when controller state is busy.
2. The second CF card error.
3. File REGISTRY.DAT is
damaged.
1. Motherboard is too hot.
2. PIO5 error
3. Motherboard error
4. Ground wire of controller is
interfered.
1. PIO5 error
2. Fram CRC error
3. Fram doesn't initialize
Users design too many texts and
pictures when they design CE
human-machine interface and
make the capacity of system
memory less than 1M.
Resolution(s)
Once this case happens, back
up the machining data of user to
new CF card and then replace
the second CF card.
Once this case happens, back
up the machining data of user to
new CF card, and then replace
the second CF card.
1. Check whether the fan turns
correctly.
2. Change the PIO5.
3. Change the motherboard.
4. Check whether the machine
touches the ground
properly.
1. For the first and the second
reason, change PIO5.
2. For the third reason, using
software version which is
from 10.112.95 or 10.114.29
on.
Human-machine interface of
controller should simplify
components, only design
effective variables and scripts to
avoid the low memory
phenomenon.