Laguna Tools SmartShop Maker Owner's Manual page 58

Error Code
Absent ':' or ',' delimiter in
CASE statement
Array Index must be Integer
File not found
Divide by zero
Operand domain error
Program loading failure
Arc not on work plane
Arc radius too short
Arc destination not on arc
58
SmartShop|Maker Owner's Manual
Potential Issue(s)
Programming error
Programming error
Programming error
Programming error
Programming error
Programming error
Programming error
Programming error
Programming error
Resolution(s)
Check MACRO program. In
CASE statement, ';' or ',' is
correct. However, the operator
should use ';' when finishing
CASE command.
Please check the machining
program, the index in MACRO
command has to be rounded.
Ex; @[ROUND(#1)+1]
Check the machining program to
verify the existence of the file.
Check the machining program to
ensure that the demominator is
not equal to zero (0).
Please check the machining
program.
Please check the machining
program
Check the machining program to
ensure that G02 and G03 are
used correctly.
Check the machining program to
ensure that the Arc radius G02
and G03 are used correctly.
Check the machining program to
ensure that the Arc radius of
G02 and G03 are used
correctly.