Table of Contents
Advertisement
Introduction
There are three ways to configure the FM530 PRO: Barcode programming, command programming and Easyset
programming.
Barcode Programming
The FM530 PRO can be configured by scanning programming barcodes. All user programmable features/options are
described along with their programming barcodes/commands in the following sections.
This programming method is most straightforward. However, it requires manually scanning barcodes. As a result, errors are
more likely to occur.
Command Programming
The FM530 PRO can also be configured by serial commands sent from the host device.
Users can design an application program to send those command strings to the scanners to perform device configuration.
EasySet Programming
Besides the two methods mentioned above, you can conveniently perform scanner configuration through EasySet too.
EasySet is a Windows-based configuration tool particularly designed for Newland products, enabling users to gain access
to decoded data and captured images and to configure scanners. For more information about this tool, refer to the EasySet
User Guide.
23
Chapter 7 Configuration
Enter Setup
** Exit Setup
Advertisement
Table of Contents
