Table of Contents
Advertisement
Enter Setup
Debugging Mode
The scanner will scan barcodes continuously after it enters the debugging mode. When a barcode is decoded, the data is
transmitted with specific formats. These settings will not be saved after restarting the scanner.
Debugging Mode 1
After the barcode is decoded, it will be output with symbology identifiers, length and data.
Enter Debugging Mode 1
Debugging Mode 2
After a barcode is decoded 100 times, it wil be output in format: good read times_data. Meanwhile, the decode session is
ended, the LED is off and the scanner restart scanning barcodes continuously 100ms later.
Enter Debugging Mode 2
** Exit Setup
Exit Debugging Mode 1
Exit Debugging Mode 2
60
Advertisement
Table of Contents
