Scan Mode
Level Mode: Driving the SW IN pin from high to low (default) activates a decode session. The decode session continues
until a barcode is decoded or the SW IN pin is pulled up.
Continuous Mode: The scanner automatically starts one decode session after another. To suspend/resume barcode
reading, simply pull up/ down the SW IN pin. Reread Timeout can avoid undesired rereading of same barcode in a given
period of time. Note that when switching to this mode by scanning the Continuous Mode barcode, the scanner will stop
barcode reading for 3 seconds before starting scanning continuously.
Batch Mode: Driving the SW IN pin from high to low (default) activates a round of multiple decode sessions. This round of
multiple scans continues until the pin is pulled up. Rereading the same barcode is not allowed in the same round.
Level Mode
Batch Mode
Decode Session Timeout
This parameter sets the maximum time decode session continues during a scan attempt. It is programmable in 1ms
increments from 1ms to 3,600,000ms. When it is set to 0, the timeout is infinite. This feature is only applicable to the Pulse,
Sense and Level modes.
37
Chapter 9 System Settings
Enter Setup
Continuous Mode
** Exit Setup