Factory Defaults Table (St.g02.5) - Newland FM530 User Manual

Factory Defaults Table (ST.G02.5)

Parameter
System Settings
Barcode Programming
Programming Barcode Data
Scan Mode
Decode Session Timeout
Scanning Interval (Continuous Mode)
Reread Timeout
Reread Timeout Reset
Good Read Delay
Read Barcode On/Off
Bad Read Message
Trigger Commands
Start Scanning Command
Stop Scanning Command
Illumination
Aiming
Good Read LED
Good Read LED Duration
Power On Beep
Good Read Beep
Good Read Beep Duration
Good Read Beep Frequency
Good Read Beep Volume
Security Level
Enable/Disable Switching Input
Trigger Slope
Trigger Duration
Debounce Duration
Enable/Disable Switching Output
Output High/Low Level
Output Duration
Enable Level Output
143
Factory Default
Disabled (Exit Setup)
Do not transmit
Trigger Mode
0ms
0ms
Enabled, 0ms
Off
Disabled, 500ms
On
3F
Disabled
<SOH> T <EOT>
<SOH> P <EOT>
Normal
Off
On
20ms
Off
Off
Medium (80ms)
Medium (2730Hz)
Loud
1
Disabled
Negative Slope
0ms
10ms
Disabled
Output Low Level
400ms
Output Level After a Good Read
Remark
1-3,600,000ms; 0: Infinite
1-3,600,000ms
1-3,600,000ms
1-7 characters
0-60,000ms
0-250ms
0-60,000ms