Custom Suffix; Set Custom Suffix; Data Packing; Introduction - Newland FM530 User Manual

Enter Setup

Custom Suffix

Set Custom Suffix

To set a custom suffix, scan the Set Custom Suffix barcode then the numeric barcodes corresponding to the hexadecimal
value of a desired suffix then the Save barcode.
Note: A custom suffix cannot exceed 10 characters.
Set the custom suffix to "CODE" (HEX: 0x43/0x4F/0x44/0x45):
1.
2.
3.
4.
5.
6.

Data Packing

Introduction

Data packing is designed for a specific group of users who want to have the data packed before transmission. Data packing
influences data format, so it is advised to disable this feature when it is not required.

Data Packing Options

² Disable Data Packing: Transmit decoded data in raw format (unpacketed).
² Enable Data Packing, Format 1: Transmit decoded data with the packet format 1 defined below.
Packet format 1: [STX + ATTR + LEN] + [AL_TYPE + DATA] + [LRC]
** Exit Setup
Scan the Enter Setup barcode.
Scan the Set Custom Suffix barcode.
Scan the numeric barcodes "4", "3", "4", "F", "4", "4", "4" and "5" from the "Digit Barcodes" section in
Appendix.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
Scan the Enable Custom Suffix barcode.
Scan the Exit Setup barcode.
Set Custom Suffix
128