Enter Setup
Disable Trigger Commands
Modify Start Scanning Command
The Start Scanning command can consist of 1-10 characters (HEX values from 0x01 to 0xFF). In this command, the
character "?" (HEX: 0x3F) cannot be the first character. The default Start Scanning command is <SOH> T <EOT>.
Set the Start Scanning command to "*T":
1.
Scan the Enter Setup barcode.
2.
Scan the Modify Start Scanning Command barcode.
3.
Scan the numeric barcodes "2", "A", "5" and "4" from the "Digit Barcodes" section in Appendix.
4.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
5.
Scan the Exit Setup barcode.
Modify Stop Scanning Command
The Stop Scanning command can consist of 1-10 characters (HEX values from 0x01 to 0xFF). In this command, the
character "?" (HEX: 0x3F) cannot be the first character. The default Stop Scanning command is <SOH> P <EOT>.
** Exit Setup
Modify Start Scanning Command
Enable Trigger Commands
44