Custom Prefix; Set Custom Prefix; Aim Id Prefix - Newland FM530 User Manual

Enter Setup

Custom Prefix

Set Custom Prefix

To set a custom prefix, scan the Set Custom Prefix barcode then the numeric barcodes corresponding to the hexadecimal
value of a desired prefix then the Save barcode.
Note: A custom prefix cannot exceed 10 characters.
Set the custom prefix to "CODE" (HEX: 0x43/0x4F/0x44/0x45):
1.
2.
3.
4.
5.
6.

AIM ID Prefix

AIM (Automatic Identification Manufacturers) ID defines symbology identifier (For the details, see the "AIM ID Table"
section in Appendix). If AIM ID prefix is enabled, the scanner will add the symbology identifier before the scanned data
after decoding.
** Exit Setup
Scan the Enter Setup barcode.
Scan the Set Custom Prefix barcode.
Scan the numeric barcodes "4", "3", "4", "F", "4", "4", "4" and "5" from the "Digit Barcodes" section in
Appendix.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
Scan the Enable Custom Prefix barcode.
Scan the Exit Setup barcode.
Set Custom Prefix
122