Advertisement
Available languages
Available languages
EN
No.
6
LIN bus and temperature sensor socket
Fig. , 7
Fig.
on page 2
No.
1
2
3
4
5
6
Battery charging function
Lead acid, AGM and GEL batteries
Fig.
on page 2
1: Analysis phase
The battery is deeply discharged (<10 %). The battery charge is analyzed with increasing charging current.
The corresponding LED indicator of the battery that is charged isflashes fast yellow.
2: I phase (Constant current phase)
At the beginning of the charging process, the empty battery is constantly charged with the maximum charging cur-
rent (100 %). The charging current decreases when the battery has reached a state of charge of 75 %. Batteries with
low voltage are charged with reduced current until the battery voltage exceeds 9 V. The duration of the I phase de-
pends on the state of the battery, the connected load and the state of charge. For safety reasons the I phase is termi-
nated after a maximum of 26 h (in case of battery cell defects or similar).
The corresponding LED blinks yellow.
3: U0 phase (Constant voltage phase)
The U0 phase starts when the battery reaches 15 V. The charging current is reduced. During the U0 phase, the bat-
tery voltage is kept constant at a high level. The duration of the U1 phase depends on the battery type and the depth
of discharge.
The corresponding LED flashes slow yellow.
4: U1 phase (Trickle charging)
The U1 phase serves to maintain the battery capacity (100 %).The U1 phase runs at lowered charging voltage and vari-
able current. If DC loads are connected, they are powered by the device. Only if the power required exceeds the ca-
14
Component
D+ signal
Component
Not connected
Not connected
Temperature sensor
Temperature sensor (common ground point of the batteries)
LIN bus communication
Not connected
Advertisement
