Fronius Welducation Simulator Operating Instructions Manual page 16

If this equipment does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
-
-
-
-
FCC Caution:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operated in conjunction with any oth-
er antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an un-
controlled environment. This equipment should be installed and operated with
minimum distance 20 cm (7.87 in.) between the radiator & your body.
This device is intended only for OEM integrators under the following conditions:
1
2
3
As long as 3 conditions above are met, further transmitter test will not be re-
quired. However, the OEM integrator is still responsible for testing their end-
product for any additional compliance requirements required with this module
installed.
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authoriza-
tion is no longer considered valid and the FCC ID can not be used on the final
product.
In these circumstances, the OEM integrator will be responsible for re-evaluating
the end product (including the transmitter) and obtaining a separate FCC au-
thorization.
End Product Labeling:
FOR MOBILE DEVICE USAGE > 20 cm (7.87 in.) / low power
This transmitter module is authorized only for use in device where the antenna
may be installed such that 20 cm (7.87 in.) may be maintained between the an-
tenna and users. The final end product must be labeled in a visible area with the
following: "Contains FCC ID: RYK-WPEQ261ACNIBT". The grantee's FCC ID can
be used only when all FCC compliance requirements are met.
Manual Information To the End User:
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user's manual of the
end product which integrates this module.
16
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The antenna must be installed such that 20 cm (7.87 in.) is maintained
between the antenna and users.
The transmitter module may not be co-located with any other transmitter or
antenna.
Module approval valid only when the module is installed in the tested host or
compatible series of host which have similar RF exposure characteristic with
equal or larger antenna separation distance.