Advertisement
ASSEMBLY
Assembly requires two persons. Set the treadmillin a cleared area and remove all packing materials. Do not
dispose of the packing matedals untilassembly is completed.
Note: The underside of the treadmillwalking belt is coated with high-performance lubricant. During shipping,a
small amount of lubricant may be transferred to the top of the walking belt or the shippingcarton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrsnc==_es and your own phillips screwdriver (__,
rubber mallet _
,wire cutters _
,and nsedlenose pliers _BS_,
•
To identify small parts during assembly, use the PART IDENTIFICATION CHART in the center of this manual.
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully raise the
Updghts (69) untilthe treadmill is in the position shown.
Insert one of the Extension Legs (63) into the treadmill
as shown. (Note: It may be helpfulto tip the Uprights as
you insert the ExtensionLeg.) Make sure that the
Warning Decal (62) is on the indicated side of the
Extension Leg.
Insert the otherExtensionLeg (63) in the same way.
63
2. With the help of a second person,carefully lower the
treadmillframe and then tip the Updghts(69) down as
shown. (Note: It may be helpfulto place your foot on an
Extension Leg [63] as you tip the Uprights.)Make sure
that the Extension Legs remain in the Uprights.
Attach each Extension Leg (63) with two 3/4" Tek
Screws (58).
Attach four Base Pads (57) with 3/4" Tek Screws (58) as
shown.
Note: One replacement Base Pad (57) may be included.
If a Base Pad becomes worn and needs to be replaced,
use the replacement Base Pad.
2
57--
j_.."
58
I
57_
e_
/
58
5
Advertisement
