Advertisement
TROUBLESHOOTING
Most treadmill problems can be solved by following the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assistance is needed, call our toll-free HELPLINE at
1-800-736-6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).
PROBLEM: The power does not tum on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor,and that the surge suppressor
is plugged into a propedygroundedoutlet (see page 8). Use only a single-outletsurge suppressor
that meets all of the specificationsdescribedon page 8. Important:The treadmillis not compatible
with GFCI-equipped outlets.
b. After the power cord has been pluggedin, make sure that the key is fully insertedintothe console.
c. Check the circuit breaker located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the circuitbreaker has tripped. To reset
the circuit breaker, wait for five minutes and then
press the switch back in.
Tripped
Reset[_
PROBLEM:
The power turns offduring
use
SOLUTION: a. Check the circuitbreaker located on the treadmill frame near the power cord (see the drawing
above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully intothe console.
d. If the treadmillstillwill not run, please call our toll-free HELPLINE.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE
POWER CORD. Remove the two 3/4" Screws (2)
from the hood, and carefully pivotthe Hood (1) off.
Locate the Reed Switch (10) and the Magnet (18) on
the left side of the Pulley (17)oTurn the Pulley untilthe
Magnet is aligned with the Reed Switch. Make sure
that the gap between the Magnet and the Reed
Switch Is about 1/8". If necessary, loosenthe Screw
(56) and move the Reed Switch slightly. Retightenthe
Screw. Re-attach the Hood, and runthe treadmillfor a
few minutes to check for a correctspeed reading.
118"--
10_
66
Top
View
17
13
Advertisement
