Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included hex key
tifying the assembly hardware, see the drawings below. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number following the parenthe-
ses is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not
in the hardware kit, check to see if it has been preassembled. To avoid damaging plastic parts, do not use
power tools for assembly.
Upright Star
Washer (90)–10
1. Make sure that the power cord is unplugged.
With the help of a second person, raise the front
of the treadmill and insert the crossbar on the
Base (83) into the cutout in the cardboard stand
as shown. Have the second person hold the
treadmill to prevent it from moving forward
or backward until assembly step 2 is com-
pleted.
WARNING:
may occur if the treadmill moves for-
ward or backward and falls off the card-
board stand. A second person must
hold the treadmill until assembly step 2
is completed to prevent the treadmill
from moving, tipping, or falling.
and your own Phillips screwdriver
3/4" Screw (4)–4
Upright Bolt (72)–4
Serious injury
6
Handrail Bolt (64)–6
1
83
. For help iden-
Cardboard
Stand
Advertisement
Table of Contents
