Advertisement
3. With the help of a second person, raise the Uprights (69)
to the vertical Position.Attach the Storage Latch (36) to
the left Upright with two 3/4" Screws (2). Remove the
Lock Knob (30) from the Lock Pin (35). Make sure that
the Lock Pin Collar (33) and the Spring (32) are on the
Lock Pin as shown. Insertthe Lock Pin intothe Storage
Latch and tighten the Lock Knob back onto the Lock Pin.
3
4. Identifythe Right Handrail (72), which has a large hole in
the left side. Feed the Wire Harness (42) up into the
bracket on the Right Handrail and out of the large hole in
the left side. (Note: It may be helpfulto use needlenose
pliersto pull the Wire Hamess out of the large hole.)
Press a Handrail Cap (76) onto the lower end of the
Right Handrail as shown.
Insert the bracket on the Right Handrail (72) into the top
of the right Upright (69) so the Handrail Cap (76) is rest-
ing against the Upright.Attach the Right Handrail and the
Handrail Cap with three 1" Bolts (37) and two Washers
(38) as shown. Firmly tighten the indicated Bolt but
do not tighten the other Bolt yet.
Attach the Left Handrail (not shown) as described above.
Note: There is not a wire harness on the left side.
Large
Hole
38
-76
5. Attach the end of the groundwire to the small hole in the
side of the Right Handrail (72) with a Silver Ground
Screw (75).
Ground
Wire
75
6
Advertisement
