Vehicle Connection; Wifi Connection; Wired Connection - Xtool N9EV User Manual

VEHICLE CONNECTION

WIFI CONNECTION

The WIFI connection method is shown in the figure below:
The scan tool must be connected to the vehicle's OBD-II port so that the tablet can establish correct vehicle communication.
Please perform the following steps:
1 Turn on the tablet
2 Connect VCI with Vehicle via main test cable and OBD adapter, make sure WIFI connection works fine
3 Switch on the ignition and tap on the Diagnostic application to start your diagnosis.
Note: The vehicle's DLC is not always located under the dash; for the location of the DLC, please refer to
the vehicle owner's manual. Some older vehicles are not compatible with the OBD
sure you're using the correct adapter.

WIRED CONNECTION

When using functions such as ECU programming & coding, please use the USB 3.0 to TYPE-B main cable to connect the
tablet to the VCI box to prevent the failure of function execution due to unstable data transmission and thus any other
damage.
5
Ⅱ
-16 adapter, please make