Xtool N9EV User Manual page 28

deactivating and activating brake control systems, assisting in controlling brake fluid, applying and releasing brake pads,
setting brakes after replacing brake discs or brake pads, etc.
1. If the brake pad wears the brake pad sense line, the brake pad sense line will send a signal to the onboard tablet asking
for replacing the brake pad. After replacing the brake pad, you must reset the brake pad to clear the trouble code.
Otherwise, the car continues to falsely notify the user that the brake pads are in need of replacement.
2. A reset must be performed in the following cases:
⚫
The brake pad and brake pad wear sensor are replaced.
⚫
The brake pad indicator lamp is on.
⚫
The brake pad sensor circuit is shorted.
⚫
The servo motor is replaced.
The operation guidelines of the EPB function are shown as below:
1. Enter the EPB menu and choose relevant models according to the vehicle being tested.
2. Follow the instructions displayed and press YES after completing the instructions shown.
3. Enter the Enter maintenance mode menu and release the handbrake brake. And press OK after completing the
instructions shown.
Wait until the message of 'Successful operation' popes up. And press OK to exit the menu.
4.
Enter the Exit maintenance mode menu and wait until the message of ''Successful operation' popes up.
5.
26