Table of Contents
Advertisement
UNIVERSAL BLUE™ RF Sensor when used with
Harmonic Scalpel Generator
(Figure 4; Placement 1 or 2):
Plug the UNIVERSAL BLUE™ RF Sensor's
1.
connector into Crystal Vision Smoke Evacuator's
ESU/Laser port.
Place the UNIVERSAL BLUE™ RF Sensor on the
2.
hand piece cable, making sure the sensor is installed on
top of the cable, facing down, to prevent capture of
residual RF signal from surrounding devices.
Use both of the self-adhering Velcro straps to wrap
3.
around the sensor and over the hand piece cable, to
secure the cable to the sensor at both ends of the sensor.
Plug the handpiece into the Harmonic Scalpel Generator.
4.
Set the Harmonic Scalpel Generator
5.
Activate the handpiece. When the handpiece is
6.
activated, the UNIVERSAL BLUE™ RF Sensor
should turn ON the Crystal Vision Smoke Evacuator
automatically.
CAUTIONS: Use only smoke evacuator accessories
manufactured by I.C. Medical, Inc. as SAFEGUARD
®
BLUE
Hydrophobic ULPA Filter with Built-in Fluid Trap,
Large Coconut Charcoal Output Filter, RF Sensor(s), smoke
tubing disposable and other accessories. Using any other
filters, sensors, or accessory, not manufactured or supplied
by I.C. Medical, Inc. may cause damage and/or cause the
system to be inoperable and may void the warranty.
FOOT SWITCH
INSTALLATION/OPERATION
If you would like to use your Smoke Evacuator independent
to other devices, proceed with the following:
1.Plug the Foot Switch's connector into the Smoke
Evacuator's ESU/Laser port as per Figure 5.
2.Depress/Release Foot Switch to activate/deactivate the
Smoke Evacuator.
Figure 4: UNIVERSAL BLUE RF Sensor installation
when used with Harmonic Scalpel generator
Figure 5: Foot Switch Installation
7
Advertisement
Table of Contents
