Trouble Shooting Guide - IC Medical CRYSTAL VISION 450D Operating And Installation Manual

Hide thumbs

Table Of Contents

Table of Contents

SYMPTOM

Be sure power cord is plugged in.

CRYSTAL

Check power switch on back panel to see if it is turned on.

VISION

Blown Fuse. (Have technically qualified personnel replace as follows: Remove fuse cover with small screw driver,

Won't Turn ON

remove fuse holder, replace fuse with F4AH 250V fuse; replace fuse holder and replace fuse cover).

Check Outlet for voltage reset circuit breaker if needed.

If none of the suggestions resolves this problem, then Unit is malfunctioning, please have technically qualified

personnel check and correct or contact I. C. Medical, Inc.

Occlusion Indicator is on. See solutions under

Pump Won't Start

Press the manual button, if pump starts then check the following;

Activation Sensor assembly is not installed, or it is not installed correctly. If

red light is "on" and that it goes out as soon as the foot pedal is depressed. If Electrosurgical Sensor is used, see

"ESU SENSOR

Sensor cable not connected to CRYSTAL VISION

used).

Press the manual button, if pump does not start then Unit is malfunctioning, please have technically qualified

personnel check and correct or contact I. C. Medical, Inc.

Unplug Sensor from the Unit, adjust TIME SETTING to minimum. If after 2 seconds pump turns off then the

Pump Runs

following may apply;

Continuously

Laser Sensor assembly not installed correctly. Be sure red light on the sensor is "ON" when the pedal is NOT

depressed and that it goes out when the pedal is depressed.

Debris blocking the light beam at the sensor assembly.

ESU Sensor is defective and will need to be repaired.

Unplug Sensor from the Unit, adjust TIME SETTING to minimum. If after 2 seconds pump does not turn off

then Unit is malfunctioning, please have technically qualified personnel check and correct or contact I. C. Medical,

Inc.

For Laparoscopic procedures, Gas is not allowed to flow freely from the pneumoperitoneum to the CRYSTAL

OCCLUSION

VISION

Indicator Is ON

clogged SAFEGUARD BLUE

continuing.

For open procedures, Blockage is occurring during the procedure, determine the blockage and clear away.

Check calibration of Occlusion Indicator (LAP flow & OPEN flow). See

Instructions.

If none of the suggestions resolves this problem, then Unit is malfunctioning, please have technically qualified

personnel check and correct or contact I. C. Medical, Inc.

Pressure exceeds 27 mmHg (±10% and 1 digit) in the pneumoperitoneum. Insufflator or argon beam

OVER PRESSURE

coagulator supplying too much gas. External Pressure (i.e., from physician's arm, etc.) to the pneumoperitoneum

Indicator Is ON

is raising the internal pressure. Correct the problem before continuing.

Check calibration of Over Pressure Indicator. Also check adjustment of the Over Pressure Threshold to Start

Pump. See

If none of the suggestions resolves this problem, then Unit is malfunctioning, please have technically qualified

personnel check and correct or contact I. C. Medical, Inc.

The CRYSTAL VISION

NO PATIENT

BLUE

Indicator Is ON

on the Trocar sheath is open.

Pneumoperitoneum may be at room pressure (no action required).

Check calibration of No Patient Indicator. See

If none of the suggestions resolves this problem, then Unit is malfunctioning, please have technically qualified

personnel check and correct or contact I. C. Medical, Inc.