Non-Laparoscopic Gynecology Procedures; Figure 21: Set Up For Gynecology Procedure For Either Esu Or Co 2 Laser Delivered Through A Colposcope Or Micromanipulator - IC Medical CRYSTAL VISION 450D Operating And Installation Manual

NON-LAPAROSCOPIC
GYNECOLOGY PROCEDURES:
1. Installation should already be completed according to the
installation instructions.
2. Be familiar with all operating controls as described in
Description of Switches, Control Buttons, and Indicators.
3. Refer to Figure 21 for set-up.
4. Connect SAFEGUARD BLUE
Filter with Built-in Fluid Trap to the CRYSTAL
VISION ® .
5. Connect Disposable Sterile Tubing Set to laser speculum
port and to the SAFEGUARD BLUE
ULPA Filter with Built-in Fluid Trap.
6. Connect ESU and/or LASER SENSOR CABLE to
SENSOR ASSEMBLY and the CRYSTAL VISION
7. Plug CRYSTAL VISION
POWER SWITCH on back panel.
8. Push OPEN (Orange) button.
9. Adjust FLOW SETTING for the desired flow rate
indicated on the display.
10. Push MANUAL button and observe the actual flow
indicated by FLOW READING display. Adjust FLOW
SETTING if necessary.
11. Adjust TIME SETTING for the desired amount of time
that the CRYSTAL VISION® runs after the smoke
producing equipment is shut off.
12. Increase the FLOW SETTING and/or the TIME
SETTING if smoke is not eliminated from the uterus.
13. CHANGE FILTER light may indicate a partially
obstructed speculum port or smoke tubing. Check and
clean them, if necessary. The SAFEGUARD BLUE®
Hydrophobic ULPA Filter with Built-in Fluid Trap
may also need to be changed.
14. OCCLUSION alarm indicates obstructed speculum port,
kinked, or obstructed tubing.
necessary. It may also mean that the SAFEGUARD
BLUE® Hydrophobic ULPA Filter with Built-in Fluid
Trap has become extremely filled with smoke particles.
Replace it, if required.
®
Hydrophobic ULPA
® Hydrophobic
®
into power outlet and turn on
Check and clean as
® .
Figure 21: Set up for gynecology procedure for either ESU
or CO laser delivered through a colposcope or
2
Micromanipulator
18