Table of Contents
Advertisement
DESCRIPTION OF SWITCHES,
CONTROL BUTTONS &
INDICATORS
The Sensor Assembly and the Large Coconut Charcoal
Output Filter should already be installed according to the
INSTALLATION INSTRUCTIONS.
1. ON/OFF SWITCH is located on the back panel (Figure
12) next to the power cord. This switch controls the
power to the CRYSTAL VISION
symbols are used. The [I] symbol indicates power
"ON" and [O] indicates "OFF."
controls the cooling fan.
2. MANUAL button (Figure 13) used to turn the
®
CRYSTAL VISION
ON when the surgeon is not
activating a smoke-producing device. The MANUAL
button can be used to clear residual plume during these
situations in (LAP) procedures. It can also be used to
clear smoke and plume if more than one device is used
and only one sensor is available. This frequently occurs
during laser cases when a sensor is attached to the laser
foot pedal and other sensors are not available to be
attached to an Electrosurgical Unit (ESU).
3. LASER CONNECTOR (Figure 13) is the input for the
LASER SENSOR CABLE. In reality, both LASER &
ESU connectors are identical and either will accept all
standard I.C. Medical sensor assemblies.
4. ESU CONNECTOR (Figure 13) is the input for the
ESU SENSOR CABLE. This sensor can be used to
activate the CRYSTAL VISION®.
®
.
International
This switch also
Figure 12: ON/OFF power switch location.
Figure 13: Manual button and sensor connectors.
12
Advertisement
Table of Contents
