Rinsing Filter; Removing/Replacing Filter - Grizzly G0638HEP Manual

Rinsing Filter

For a thorough cleaning, the filter can be removed
and rinsed off. However, make sure to clean the
filter with the brush system first. Allow the filter to
air dry, but never leave the filter in the sun to dry
or it could become damaged.
Removing/Replacing
Filter
The filter for canister filter assemblies manufac-
tured since November, 2009, can be removed
from the assembly so that it can be replaced or
rinsed off (see the instructions in the next subsec-
tion).
Removing/installing the filter requires removing
the canister filter assembly from the dust collec-
tor and disassembling it. Follow the instructions
below to perform this procedure.
Refer to the parts breakdown diagrams and list-
ings beginning on Page 60 to order the correct
filter from Grizzly at (800) 523-4777.
Tools Needed
Open-End Wrench 10mm .................................. 1
Wrench or Socket 12mm ................................... 2
To replace the canister filter:
1. DISCONNECT MACHINE FROM POWER!
2. Remove the bag clamp and collection bag
from the canister assembly.
-48-
3.
Pull the black handle all the way down and
secure the cable into the handle hook at the
bottom of the canister assembly, as shown in
Figure 89, to hold it in place during the fol-
lowing steps.
Figure 89. Black handle cable secured in the
4. Remove the canister assembly from the
dust collector and place it right-side up on a
stable, flat surface.
5.
Remove the six hex bolts, hex nuts, and flat
washers from the rim of the canister base, as
shown in Figure 90.
Qty
Canister
Base
Figure 90. Removing the hex nuts and flat
washers from the rim of the canister base.
Model G0637/G0638 (Mfd. Since 04/12)
Red
Handle
Hook
Black
Handle
handle hook.