Table of Contents
Advertisement
28. Apply the 3 x 6 x 1100mm gasket to the
square side of the outlet port.
29. Attach (1) 3 x 15 x 700mm gasket to the outer
circular rims of each outlet port.
30. Mount the outlet port to the blower hous-
ing with (4)
⁄
"-18 x 1" hex bolts, (8)
5
16
flat washers, and (4)
Figure 31).
Outlet Port
Gasket
Figure 31. Filter L-braces mounted to blower
housing.
31. Attach the filter L-braces to either side of the
outlet port on the blower housing with (6)
18 x 1" hex bolts, (12)
(6)
⁄
"-18 hex nuts.
5
16
32. Secure the short filter brace support to the
back of the filter L-braces with (2)
hex bolts, (4)
⁄
" flat washers, and (2)
3
8
hex nuts (see Figure 32).
Short
Brace
Support
Figure 32. Short filter brace support attached.
-26-
⁄
"
5
16
⁄
"-18 hex nuts (see
5
16
Outlet Ports
w/Gaskets
Filter
L-Braces
⁄
"-
5
16
5
⁄
" flat washers, and
16
⁄
"-16 x
⁄
"
3
3
8
4
⁄
"-16
3
8
33. Attach the two long brace supports to the
filter braces with (4)
⁄
" flat washers, and (4)
3
8
shown in Figure 33.
Figure 33. Long brace supports attached.
34. With assistance, position the rubber mount-
ing gaskets between the filter canisters and
the long brace supports, and secure the can-
isters with (8)
⁄
"-18 x
5
16
" fender washers (see Figure 34).
⁄
5
16
Gasket
Rubber
Gaskets
Here
Figure 34. Canister filters mounted to the long
support braces.
Model G0637/G0638 (Mfd. Since 04/12)
3
⁄
"-16 x
3
⁄
" hex bolts, (8)
8
4
⁄
"-16 hex nuts, as
3
8
⁄
" hex bolts and (8)
3
4
Mounting
Bolts
Advertisement
Table of Contents
