Table of Contents
Advertisement
35. Attach the 3 x 15 x 700mm gaskets to the
upper rim of the canister filter assembly and
both rims of the noise muffler.
36. Assemble the 8" x 31
noise mufflers, and the 8" x 4
with the 8" duct clamps (see Figure 35).
Noise
Muffler
Figure 35. Ducting and noise muffler connected
between blower housing and filter canister.
37. Use the 8" duct clamps to connect the duct
assemblies between the outlet port of the
blower housing and the canister filters.
38. Fit the smaller plastic collection bags over
the bottom of the filters and clamp them in
place with the metal bag clamps, as shown in
Figure 36.
Figure 36. Canister filter collection bag installed.
Model G0637/G0638 (Mfd. Since 04/12)
⁄
" flexible ducts, the
1
2
⁄
" flexible ducts
3
4
Flexible
Ducts
Bag Clamp
39. Apply the 3 x 6 x 2200mm gasket to the larg-
er, top end of the small cyclone funnel, then
place the cyclone funnel upside down on the
floor.
Note: Use a clean covering on the floor to
protect the gasket.
40. Apply the 3 x 6 x 735mm gasket to the top of
the funnel port and place this upside down on
top of the cyclone funnel.
41. Attach the small cyclone funnel and funnel
port with (6)
⁄
"-18 x 1
5
16
flat washers, and (6)
42. With assistance, attach this assembly to the
bottom of the large cyclone funnel with (9)
⁄
"-18 x 1
⁄
" hex bolts, (18)
5
1
16
4
and (9)
⁄
"-18 hex nuts (see Figure 37).
5
16
Small
Cyclone
Funnel
Figure 37. Small cyclone funnel and funnel port
attached.
⁄
" hex bolts, (12)
⁄
"
1
5
4
16
⁄
"-18 hex nuts.
5
16
⁄
" flat washers,
5
16
Funnel
Port
-27-
Advertisement
Table of Contents
