Table of Contents
Advertisement
11. With assistance, place intake barrel over
large cyclone funnel and align mounting
holes as illustrated in Figure 13.
Intake Barrel
Mounting Holes
Group
of
Three
Large Cyclone
Figure 13. Intake barrel and large cyclone funnel
mounting holes aligned.
NOTICE
When connecting parts that have gasket
applied to mounting surface, always tighten
fasteners in opposing star pattern to ensure
gasket does not become crimped and com-
promise seal.
12. Connect intake barrel and large cyclone fun-
nel with (12)
⁄
"-18 x 1
5
16
⁄
" flat washers, and (12)
5
16
in mounting holes—excluding left and right
holes in groups of three (see Figure 14).
Excluded
Holes
Large Cyclone
Funnel
Figure 14. Intake barrel and large cyclone
funnel.
-8-
Funnel
⁄
" hex bolts, (24)
1
4
⁄
"-18 hex nuts
5
16
Intake
Barrel
x 12
13. Install (4) cyclone mounting brackets with (8)
⁄
"-16 x 1
⁄
" hex bolts, (16)
3
1
8
4
"-16 lock nuts (see Figures 15).
and (8)
⁄
3
8
x 8
Figure 15. Cyclone mounting bracket mounted
to collector assembly.
14. Apply remaining 700mm diameter barrel gas-
ket to top mating surface of intake barrel
assembly.
15. With intake barrel assembly on floor, lower
blower housing assembly until it is about one
inch away from intake barrel assembly.
16. Using two punches or Phillips screwdrivers
as alignment guides (see Figure 16), lower
blower housing assembly onto intake barrel
assembly.
Note: Orient both assemblies so that large,
round intake port of intake barrel is NOT
directly underneath rectangular outlet port
of blower housing (see Figure 16). Outlet
port connects to canister filters and will not
allow room for attachment of intake ducting
to intake port.
Inlet
Port
Figure 16. Aligning mounting holes.
Model G0638HEP (Mfd. Since 7/20)
⁄
" flat washers,
3
8
Advertisement
Table of Contents
