Table of Contents
Advertisement
18. Apply the 3 x 6 x 300mm foam tape to the
mating surface of the cyclone vacuum port,
then attach it to the cyclone funnel with (4)
⁄
"-18 x
⁄
" hex bolts and (4)
5
3
16
4
(see Figure 28).
Figure 28. Cyclone vacuum tube and hose
attachment.
19. Lower the blower/intake assembly into the
upper stand assembly so that the cyclone
mounting brackets align with the mount-
ing holes of the upper stand braces (see
Figure 29).
Cyclone
Mounting
Brackets
Figure 29. Mounting blower/intake assembly to
upper stand.
20. Secure the mounting brackets to the upper
stand with (8)
⁄
"-16 x
3
8
flat washers, and (8)
21. With assistance and the power lifting equip-
ment, raise the entire assembly high enough
to install the lower stand legs.
Model G0637/G0638 (Mfd. Since 04/12)
⁄
" flat washers
5
16
Vacuum Port
⁄
" hex bolts, (16)
⁄
"
3
3
4
8
⁄
"-16 lock nuts.
3
8
22. Slide the four lower stand legs onto the bot-
toms of the upper stand legs—do NOT install
the fasteners yet.
23. Slowly lower the weight of the assembly onto
the lower stand legs.
Note: To keep the assembly stable while
completing the next steps, keep the power
lifting equipment engaged but not lifting.
24. To allow the mounting holes of the lower
stand legs to align properly, slightly loosen
the 16 fasteners that connect the lower
stand braces to the upper stand legs (see
Figure 30).
Lower Stand Brace Fasteners
Lower
Stand
Legs
Figure 30. Lower stand legs attached to the
upper stand assembly.
25. Secure the lower stand legs to the upper
stand assembly with (24)
bolts, (48)
⁄
" flat washers, and (24)
3
8
lock nuts.
26. Re-tighten the 16 fasteners connecting the
lower stand braces to the assembly.
27. Remove the power lifting equipment from the
assembly.
Note: The only other use for the power lift-
ing equipment is moving the dust collection
system into its permanent position when the
assembly is complete.
⁄
"-16 x
⁄
" hex
3
3
8
4
⁄
"-16
3
8
-25-
Advertisement
Table of Contents
