12
WHEELS
12.5.2
Installing the rear wheel
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents No braking effect when operating the rear brake.
–
After installing the rear wheel, always operate the foot brake until the pressure point is reached.
–
Remove nut
–
Holding the rear wheel, withdraw wheel spindle
adjuster.
–
Push the rear wheel forward as far as possible and take the chain off the rear
sprocket.
–
Pull the rear wheel back and take it out of the swingarm.
B01549-10
Main work
(Duke COL)
–
Check the rear hub rubber dampers. (
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
–
Clean and grease the shaft seal rings
Long-life grease (
–
Clean the thread of the wheel spindle and nut
–
Clean the fixing locations on the brake caliper support and swingarm.
–
Install the rubber damper and rear sprocket carrier on the rear wheel.
B00748-10
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Position the rear wheel on the contact surfaces in the swingarm.
–
Push the rear wheel as far forward as possible and place the chain on the rear
sprocket.
and the washer. Remove chain adjuster
3
Warning
Danger of accidents Reduced braking effect caused by damaged brake
discs.
–
Always lay the wheel down in such a way that the brake discs are not
damaged.
Info
Do not operate the foot brake when the rear wheel is removed.
Change the wheel bearing.
p. 270)
.
4
with the washer and chain
54
p. 73)
and mating surfaces
of the spacers.
1
A
.
2
65