Checking The Brake Fluid Level Of The Front Brake - KTM 125 Duke 2013 Repair Manual

14 BRAKE SYSTEM
14.3

Checking the brake fluid level of the front brake

Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule.
–
Press the brake piston back to its basic position and make sure that no brake
fluid overflows from the brake fluid reservoir. Suction it off if necessary.
307308-10
–
Position brake linings
307307-10
–
Position springs
The arrow on the spring points in the direction of travel.
–
Mount pin
–
Activate the hand brake lever until there is a firm pressure point.
307306-10
–
Correct the brake fluid level to level
Guideline
Level
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
307303-10
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Check the brake fluid level in viewer
If the brake fluid is below the MIN marking:
»
–
Add front brake fluid. (
C00200-10
Info
Protect the components against damage.
.
7
Info
Always change the brake linings in pairs.
.
6
.
5
Info
Make sure the springs are seated correctly.
A
Info
Clean up overflowed or spilt brake fluid immediately with water.
1
p. 83)
.
A
5 mm (0.2 in)
p. 268)
.
82