Table of Contents
Advertisement
14
BRAKE SYSTEM
–
Open shut-off valve
–
Ensure that the filling pressure is set on pressure gauge
pressure on pressure regulator
Guideline
Filling pressure
201494-11
–
Pull off dust cap
Bleeding device (00029013100) (
–
Open bleeder screw
–
Tighten the bleeder screw.
–
Close shut-off valve
–
Open the bleeder screw again until no more brake fluid emerges.
–
Tighten the bleeder screw. Remove the bleeder bottle hose. Attach the dust
cap.
–
Disconnect the bleeding device. Remove the bleeder cover.
307296-10
–
Stand the vehicle upright.
–
Correct the brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Refit screw cap with membrane.
–
Check the foot brake lever for a firm pressure point.
307297-10
.
3
Info
Follow the operating instructions of the bleeding device.
if necessary.
B
of the bleeder screw. Connect the bleeder bottle hose.
4
by approximately one half turn.
5
Info
Drain until fresh brake fluid emerges in the bleeder bottle hose without
bubbles.
.
3
Info
Overfilling of the brake fluid reservoir is prevented.
.
A
Info
Clean up overflowed or spilt brake fluid immediately with water.
. Correct the filling
A
2... 2.5 bar (29... 36 psi)
p. 272)
p. 268)
93
Advertisement
Table of Contents
