Unit Withdrawal And Insertion - GE 469 Manual

2.1 MECHANICAL
TURN OFF CONTROL POWER BEFORE DRAWING OUT OR RE-INSERTING THE RELAY TO
PREVENT MALOPERATION!
CAUTION
If an attempt is made to install a unit into a non-matching case, the mechanical key will pre-
vent full insertion of the unit. Do not apply strong force in the following step or damage may
2
result.
CAUTION
To remove the unit from the case:
1. Open the cover by grasping the center of the right side and then pulling the cover, which will rotate about
the hinges on the left.
2. Release the locking latch, located below the locking handle, by pressing upward on the latch with the tip of
a screwdriver.
3. While holding the latch raised, grasp the locking handle in the center and pull firmly, rotating the handle up
from the bottom of the unit until movement ceases.
2-4
Figure 2–6: PRESS LATCH TO DISENGAGE HANDLE
Figure 2–7: ROTATE HANDLE TO STOP POSITION
469 Motor Management Relay
2 INSTALLATION

2.1.4 UNIT WITHDRAWAL AND INSERTION

GE Power Management