Unit Withdrawal And Insertion - GE Multilin 350 Series Instruction Manual

MECHANICAL INSTALLATION

2.1.4 Unit withdrawal and insertion

NOTE: IT IS THE RESPONSIBILITY OF THE USER TO ENSURE THAT THE EQUIPMENT IS INSTALLED, OPERATED, AND USED FOR ITS
INTENDED FUNCTION, IN THE MANNER SPECIFIED BY THE MANUFACTURER. IF THIS IS NOT THE CASE, THEN THE SAFETY PROTECTION
PROVIDED BY THE EQUIPMENT MAY BE IMPAIRED.
2–6
Courtesy of NationalSwitchgear.com
KEEP THE HANDLE IN ITS ROTATED
POSITION UNTIL THE DRAW-OUT UNIT
IS INSERTED COMPLETELY
8 - 32X3/8IN P/HD PHIL BLK
GE PART # 1408-0306; (QTY:8)
TIGHTENING TORQUE: 15 IN LB
THE HANDLE MUST BE ROTATED 90
WHILE SLIDING THE 350 DRAW-OUT
UNIT INTO THE CAPTIVE UNIT
PUSH THE HANDLE DOWN AND TIGHTEN
THE SCREW UNTIL THE HANDLE IS PARALLEL
WITH THE FRONT PANEL SURFACE
350 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 2: INSTALLATION
⁰