Changing Registration Details; Deleting Devices - Sony IPELA NSR-1200 User Manual

Note
If registration for a camera fails, start your Web browser
and connect directly to the camera to confirm that images
from the camera are displayed. In addition, use the IP
address you entered in the Web browser for the camera's
IP address.

Changing Registration Details

This section describes the procedure for changing the
settings on the [General] tab of the Device Configuration
screen.
The items on the [General] tab allow you set multiple
cameras simultaneously.
Note
Some of the setting items differ depending on whether you
are configuring the settings of one camera or the settings
of multiple cameras simultaneously.
• A blank is displayed for setting items with which the
setting state differs for each camera. If these setting
items are saved as is, the corresponding setting items of
each camera are not modified. Reselecting an item from
a list or entering a numeral sets the new value for all of
the cameras.
• If a common value cannot be set for multiple cameras,
that setting item is unavailable. Change the combination
of cameras to select, and then configure the setting.
1
Select the camera(s) you want to change the
registration details of on the Device Configuration
screen.
You can also select multiple cameras at once by
holding down the Shift key or Ctrl key while selecting.
The camera registration details appear.
2
Click the [General] tab, and modify the settings of the
items you want to change.
38
Registering Devices
For details on each of the items, refer to "Setting Items
of the [General] Tab" (page 41).
For details on Generic Camera, refer "Settings
Required when Using SNC-CS20/CM120/DS10/
DM110/DS60/DM160" (page 39).
3
After configuring each item, click [Apply].
The settings are changed.

Deleting Devices

1
Select the camera you want to delete on the Device
Configuration screen.
You can also select multiple devices at once by
holding down the Shift key or Ctrl key while selecting.
2
Click (Delete).
A confirmation message appears.
3
Click [Yes].
The device is deleted.
Caution
• When a camera is deleted, "No Camera" is displayed in
the monitoring window in the layout. When you register
a camera in the default layout, the camera is assigned to
the first empty ("No Camera") monitoring window
available.
• If you delete a camera, you will no longer be able to find
data recorded with that camera. The recorded data is not
deleted at that time. The recorded data becomes target
for deletion at the point in time when the criteria for
deleting the recordings or overwriting the data in storage
are met. For details, refer "Configuring Settings Related
to Storage" (page 77).