Sony IPELA NSR-1200 User Manual page 46

Turning on the View-DR function allows the camera to
improve the visibility of images, reducing overexposure
and underexposure even in high-contrast environments,
such as under backlighting, by combining the normal
image with an image taken at high shutter speed.
Visibility Enhancer
If the camera is equipped with the Visibility Enhancer
function, select [High], [Middle], [Low], or [Off] as the
amount for the camera to automatically adjust the image
brightness and contrast.
When you turn on the Visibility Enhancer function, the
camera optimizes the contrast pixel-by-pixel,
compensating for the overexposure of bright areas and for
the underexposure of dark areas. This allows the camera to
record a vivid image even in high-contrast environments,
such as under backlighting.
If you do not want to use the Visibility Enhancer function,
select [Off].
XDNR
If the camera is equipped with the XDNR function, select
[High], [Middle], [Low], or [Off] as the strength of the
noise reduction filter applied by the camera to reduce the
amount of image noise.
When you turn on the XDNR function, the camera
distinguishes between noise occurring in areas of the
image without motion and those with motion, and
performs the appropriate noise reduction on each for better
image visibility.
This improves the effectiveness of the camera under
lowlight conditions.
If you do not want to use the XDNR function, select [Off].
IR Illuminator
If the camera is equipped with the IR illuminator function,
configure the operations of the infrared sensor.
Mode
Select [Sync with Day/Night] or [Off].
When [Sync with Day/Night] is selected, the infrared
sensor operates in coordination with the switch
between day and night.
If you do not want to use the infrared sensor, select
[Off].
Maximum Strength
Select the maximum strength of the infrared beam.
Six levels are available for the maximum strength,
with 1 as the weakest and 6 as the strongest.
46
Configuring Camera Video Settings
Edge Storage
Select this check box if the camera is equipped with an
Edge Storage function and you want to download the
images stored on the camera's Edge Storage.
When this function is enabled and a video loss occurs
during a recording schedule or the unit restarts, video is
recorded to the camera's Edge Storage, allowing you to
retrieve the data later after the system is restored.
In addition, the following settings on the camera will be
configured automatically when this function is enabled.
Setting Configuration
Edge Storage On
Overwrite setting Off
Video recording Image 1 or Image 2
Audio recording Off
Recording If Image 1: 1 second before alarm/event
duration start, 10 seconds after alarm/event start
If Image 2: 0 seconds before alarm/event
start, 10 seconds after alarm/event start
Recording mode Alarm recording, Condition: 1, 1: Network
disconnection, Monitoring IP: IP address
of this unit
Active time frame Always
Caution
• A recording schedule must be configured to use this
function.
• For details on the recommended values for the video
settings, refer to the release notes for the camera.
Setting Items of [Video] Tab (for the
SNC-XX600 series)
Configure each setting for [Image 1] to [Image 3], and
specify the video codec to use for monitoring and manual
recording.
After configuring each item, click [Apply] to save your
settings.