Monitor Frame - Sony IPELA NSR-1200 User Manual

Monitor Frame

A
G
A Camera Name
This displays the name of the camera.
B Bandwidth
This displays the amount of bandwidth used for
transferring images over a network connection.
C Frame Rate
This displays the speed at which images are imported
from the camera.
D VMD (Recorder):
This displays the detection criteria for Video Motion
Detection (Recorder).
E Display Images per Second
This display the speed at which the camera images are
refreshed on the monitor.
F Time
This displays the current date and time during the
monitoring and recording of live images, and the date
and time at the time of recording when playing back
recorded images.
G State
This displays the recording type (MANUAL,
ALARM, SCHEDULE, or EVENT) during recording.
During the playback of recorded images, the playback
operation state (PAUSE, etc.) or playback speed (+1x,
-0.2x, etc.) is displayed ("+" is used to indicate
playback speed in the forward direction, and "-" to
indicate playback in the reverse direction).
120
Monitoring
Notes
• In the monitor frame is set as the hotspot, the images of
the corresponding camera are displayed in cases such as
B
the following.
– When the monitor frame is selected.
C
– When there was a sensor input.
– When an alarm, such as motion detection alarm
occurred.
• A red frame will appear around the camera image of a
D
monitor frame when alarms, such as sensor input and
motion detection, occur on that camera.
Switching a Monitor Frame to 1×1 View
E
F Double-click on a monitor frame to switch the layout of
that monitor frame to 1×1 view.
Double-click the monitor frame again to restore the
original layout.
Note
If you switch to another layout or the layout is switched by
an action or layout tour after switching to 1×1 view,
double-clicking will not restore the original layout.