Settings Required When Using Snc-Cs20/Cm120/Ds10/Dm110/ Ds60/Dm160 - Sony IPELA NSR-1200 User Manual

Settings Required when Using SNC-
CS20/CM120/DS10/DM110/DS60/
1)
DM160
With the following six models
are restricted depending on the setting values of the
functions to be used. It is necessary to prioritize and select
the functions you want to use before you configure various
settings.
• SNC-CS20
• SNC-DS10
• SNC-DS60
Flow when Using SNC-CS20/CM120/DS10/
1)
DM110/DS60/DM160
When using any of the above cameras, first select the
combination of functions to use, and then configure
various settings. First, you must select a combination of
functions and then perform the setup. When you select the
combination of functions, the setting range for each item is
determined automatically. Therefore, it is important to
select the combination of functions carefully according to
the intended use of the camera.
1 Select the combination of functions to use
2 Configure the necessary settings in each setup screen
3 Start operation
1) Setting restrictions may also exist on future camera models. When using a
camera for which the [Function Selection] tab appears, be sure to
configure a combination of functions as you would with the above
cameras.
Caution
• The available settings and setting value ranges will vary
depending on the function combination. Be sure to
configure the settings to match the intended operation.
Example 1: When a certain codec is used, the motion
detection function will not be available. Choose a
combination with this codec only if motion
detection function settings are not required.
Example 2: When a combination with an available
setting value range of 1 to 50 has been selected, the
available range on the respective setup screens
will be limited to 1 to 50 even if the camera setting
range is 1 to 100.
• Be sure to select the function combination first and then
configure the settings. If you select or change the
function combination after starting to configure settings,
the available ranges for values will also change
depending on the function combination, which may lead
to earlier settings being altered.
1)
of camera, other functions
• SNC-CM120
• SNC-DM110
• SNC-DM160
↓
↓
Example: 70 was selected for an item with an available
range of 1 to 100, but the available range later
became 1 to 50 because of a function combination
change, and the setting was altered to 25.
• After changing a setting, be sure to check all settings
before starting operation. If the changed value is within
the available range, there will be no problem, but if it is
out of range, the setting will automatically be changed to
a value within the range.
1
Click [Select Camera Function] on the [Function
Selection] tab of the Device Configuration screen.
A screen for selecting the function combination to use
with camera appears.
2
Select the function combination one line at a time in
order from the top left, and click the [OK] button.
Select the function you want to set with [Item], and
select the setting value with [Parameter].
Notes
• The control range is narrowed down based on your
item selection sequence and parameters. The items
and values selectable on subsequent lines will
change accordingly.
• If you change a selected line, all lower lines will
revert to the non-selected condition. Note that the
function combination selected here determines the
setting range for the various setup screens.
3
Configure the other items on the [General] tab.
Also configure the settings in each screen as
necessary.
39
Registering Devices