Adjusting The Steel Suspension Fork Negative Deflection - Bosch KETTLER KB064-ZAFD Series Translation Of The Original Operating Instructions

.
Rider weight AION, NEX
< 55 kg 35 - 50 psi
55 - 65 kg 50 - 60 psi
65 - 75 g 60 - 70 psi
75 - 85 kg 70 - 85 psi
85 - 95 kg 85 - 100 psi
< 100 kg + 105 psi
Max. pressure 150 psi
Table 52: Filling pressure table for Suntour air forks
 Measure the distance between the crown and
the dust wiper of the fork. This distance is the
total deflection of the fork.
 Push a temporarily attached cable tie
downward against the dust wiper of the fork.
 Put on your usual bicycling clothing, including
luggage.
 Sit on the pedelec in your usual riding position
and support yourself (e.g. against a wall or
tree).
 Get off the pedelec without allowing it to
deflect.
 Measure the distance between the dust wiper
and the cable tie. This dimension is the sag.
The sag value should be between 15% (hard)
and 30% (soft) of the total fork deflection.
 Increase or reduce the air pressure until you
have reached the desired sag.
 Once the sag is correct, re-tighten the blue air
cover cap clockwise.
 If you cannot achieve the desired sag, you may
need to make an internal adjustment. For this
purpose, contact your specialist dealer.
MY20K01-12_1.0_12.06.2019
6.3.5.3 Adjusting the steel suspension fork
XCR 32, XCR 34
40 - 55 psi
Only applies to pedelecs with this equipment
55 - 65 psi
You can adjust the fork by tensioning the spring to
65 - 75 psi
the rider's weight and their preferred riding style.
It is not the coil spring hardness which is adjusted;
75 - 85 psi
it is its pre-tensioning. This reduces the fork's
85 - 95 psi
negative deflection when the rider sits on the
pedelec.
+ 100 psi
180 psi
Figure 61: Negative deflection setting wheel on the
suspension fork crown
 The setting wheel may be located under a
 Turn the negative deflection setting wheel in a
 The ideal setting in relation to the weight of the
negative deflection
plastic cover on the suspension fork crown.
Remove the plastic cover by pulling it off
upwards.
clockwise direction to increase the spring pre-
tensioning. Turn the negative deflection setting
wheel in an anti-clockwise direction to reduce
it.
rider has been achieved when the shock
absorber deflects 3 mm under the stationary
load of the rider. Reattach the cover after the
adjustment.
Operation
64