Installing The Wheel In The Suntour Fork; Screw-On Axle (12Ah2 And 15Ah2) - Bosch KB069 RW Series Translation Of Original Operating Instructions

5.3.4

Installing the wheel in the SUNTOUR fork

Only applies to Suntour forks with this equipment

5.3.4.1 Screw-on axle (12AH2 and 15AH2)

Only applies to Suntour forks with this
equipment
Before installing the wheel, ensure that the O-ring

is in the right position on the thread piece.
1 Insert the front wheel into the fork ends.
2 Insert the axle into the hub on the drive side.
Figure 81: Inserting the axle in the direction of the arrow
3 Use a 6 mm hex key to tighten the axle using
between 8 and 10 Nm. The axle thread must
be visible.
Figure 82: Tighten the axle in the direction of the arrow
MY23K0a - 52_1.0_02.09.2022
4 Insert the securing screw on the non-drive
side.
Figure 83: Inserting the securing screw
5 Tighten the securing screw with a 5 mm hex
key using between 5 and 6 Nm.
Figure 84: Tightening the securing screw
 The wheel is now fitted.
Assembly
103